How and what seal stamp between tiles in the bathroom
When repairing the bathroom, the question inevitably arises how to ensure that the gap between the tiles and the bathroom is narrow to prevent water from entering the floor. The situation in solving this problem can initially be of two types: The walls are not finished and the bathroom is not yet installed; Walls are made, you need to install a bath. Consider solving the problem of sealing joints in both cases.
Common for bathroom installation after wall covering
The technique of closing the joint in this case depends on the material of the bath. If the product is made of cast iron, the large weight of the bathroom allows you to install it in the right place without additional fixation by installing on the walls and closing the seams in one way. You will need a grout sealer. Find the best grout sealer in the market. But the guaranteed positive result will remain the installation of the bathroom in the grooves previously cut in the lining: Marking of alcoholic oceans in an area adjacent to the walls of the bathroom; Production of tile cut by the mill to a depth of 3-5 cm along the perimeter; Cut the chisel grooves inside the contour to install a bath in them.
Common with tiles of acrylic bath
If the bathroom is made of acrylic, its weight is minimal, so there is a possibility of displacement during operation and as a result, there is a breach of the tightness of the joint with the tiles. The rear walls of these bathtubs are flat, because the pieces in the wall of the groove to install such a bath is not practical.
Wide welding joints
If the pelvic curvature between the bathroom and tiles is between 0.5 and 5 cm, due to the large curvature of the walls or for some other reason, fixing foams are used for the basic closure of this joint. It does not matter the type of foam assembly (winter, summer and all seasons). Stitches are cleaned of dirt, dust, moisturizing. Foam openings of appropriate sizes are inserted into the gap to a depth of 3-5 cm so that the foam does not fall when filling the hole. The side of the bathroom and the tiles along it should be covered with a 5 cm wide coating strip, which will protect the surfaces from contamination with excess foam. The layers are then filled with foam by a third of the volume, which hardens 6-8 hours after installation. After removing the excess foam adhesion by cutting it with a stationary knife along the slit on the sides of the bathroom and tiles.
If the width of the clutch along the bathroom is fixed, its length is clear with a silicone sealant better called "tub", plastic glue wrap the desired cross-section and the same tone lining. On the contact surface and dry contact surfaces in the plastering board, use the syringe and the level of the silicone layer. The base is applied to the dry surface for cutting foam, mounting tiles, and pressing. The excess silicon that comes out of the seam is immediately removed with a damp cloth. The sealant is completely cured after 24 hours, after which the protective coating strip is removed. If the seam between the sink and the tiles is uneven, dry foam sealant surface is applied to the pieces to match the color of the bathroom decorate and align it with one longitudinal motion of a narrow spatula or wet brush with hard bristles. The day after removing the protective coating tape, if possible, cut out foam rubber.
Seal tight joints
The tight joints are sealed by a silicone sealant, damp-proof or both materials, and are inserted into the seam steadily. Silicone Stitches are cleaned of excess glue from debris and debris and dried by a household hairdryer, and adjacent surfaces are protected from contamination with a coating tape. The gap cavity is then filled with silicone for "aquariums" using a mounting syringe. The tip of the silicone tube is cut so that its diameter after trimming allows the injection into the depth of the filling cavity and is fully filled with the sealant. The excess silicon that came out of the hole is also removed by aligning one longitudinal movement of the narrow spatula, after which it is best to remove the protective coating strip immediately. After a day, the sealant completely freezes.l
